Independent reviews for US buyers · Reader-supported

Reader-supported: we may earn a commission from brands when you buy through our links, at no extra cost to you. Affiliate Disclosure

Reviews · 1,024 Wh

Anker SOLIX C1000 Gen 2 Review: Specs, Runtime & Who Should Buy It

By GridlessLab Editorial · Updated November 17, 2026

Check current price →Opens the retailer’s site. We may earn a commission.

Quick verdict

8.7/10
Rated capacity1,024 Wh
AC output2,000 W

A light, powerful 1 kWh LiFePO4 station: 2,000W output, 600W solar and a 10 ms UPS at under 25 lb. The catch is that it cannot be expanded.

Figures on this page are manufacturer specifications; we have not measured this unit ourselves.

Overview

Anker’s SOLIX C1000 Gen 2 packs 1,024 Wh of LiFePO4 into a 24.9 lb box with a 2,000W inverter (3,000W peak). That is more output and less weight than most 1 kWh rivals, and it is why it keeps showing up in “best value” lists.

This Anker SOLIX C1000 Gen 2 review is research-based: we used Anker’s official US spec sheet and our own runtime maths, and we have not tested the unit ourselves. Our yardstick for any backup battery is simple: does it carry the essentials through a long evening, and can it refill fast once the power is back? The C1000 Gen 2 is built around that second part.

Who it’s for

Is the Anker SOLIX C1000 Gen 2 right for you?

  • Buy it if: you want the most output per pound in the 1 kWh class
  • Buy it if: you get short, frequent outages and need fast recharges
  • Buy it if: you want TOU (time-of-use) scheduling from the app
  • Skip it if: you might want more capacity later: it is not expandable
  • Skip it if: you need lots of solar: 600W max is lower than EcoFlow or BLUETTI rivals

Key specs

Rated capacity1,024 Wh
Battery chemistryLiFePO4 (LFP)
Rated cycle life4,000 cycles to 80%
Continuous AC output2,000W
Surge / boost3,000W peak
AC outlets120V AC outlets, 2,000W max
USB & DC outputsUSB-C up to 140W, USB-A
Max solar input600W max (11–60V)
Wall charging1,200W standard; 1,600W UltraFast mode (app)
UPS / switchover<10 ms
ExpandableNo (Anker says the C1000 Gen 2 is not expandable)
Weight24.9 lb
Also worth knowingTime-of-Use mode in the app; up to 10 devices at once
Manufacturer specifications from the official Anker SOLIX product page, checked November 2026. Not measured by us.

What stands out

2,000W from a 25 lb box

The 2,000W continuous rating (3,000W peak) covers things like a microwave, a coffee maker or a small space heater that 1,500W and 1,800W rivals struggle with. Anker’s spec sheet also lists 1,800W bypass when plugged into the wall, so the unit can pass grid power through to bigger loads.

Fast wall charging, with a caveat

Standard AC charging is 1,200W, and an UltraFast mode in the app raises it to 1,600W. Anker’s own FAQ notes UltraFast only works when the cells are above about 68°F and recommends using it only when needed to protect battery life. That is an honest caveat worth remembering in a cold garage.

A real 10 ms UPS

Anker lists a sub-10 ms switchover and specifically mentions CPAP machines and laptops. For a router, modem and a PC, that’s quick enough to ride through an outage without a reboot in most cases.

No expansion, by design

Anker says plainly that the Gen 2 dropped the expansion port to save size and weight, and points people who want expansion to the original C1000. If 1 kWh will always be enough for you, this is not a problem; if you hope to grow into whole-fridge, multi-day backup, look at the C2000 Gen 2 or DELTA 3 Plus.

How it compares

Here is how the Anker SOLIX C1000 Gen 2 lines up against the models we would cross-shop it with. “Wh per lb” is a quick way to compare how much energy you carry for the weight.

ModelCapacityAC outputWeightWh per lbMax solar
Anker SOLIX C1000 Gen 21,024 Wh2,000W24.9 lb41 Wh/lb600W max
EcoFlow DELTA 3 Plus1,024 Wh1,800W27.6 lb37 Wh/lb1,000W total
DJI Power 1000 V21,024 Wh2,600W31.3 lb33 Wh/lbn/a
Jackery Explorer 1000 v21,070 Wh1,500W23.8 lb45 Wh/lb400W max
BLUETTI Elite 100 V21,024 Wh1,800W25 lb41 Wh/lb1,000W max
Manufacturer specifications, checked November 2026.

What the cycle rating means: Anker SOLIX C1000 Gen 2 is rated for 4,000 cycles to 80%. One full charge and discharge every day would use that up in about 11 years; a full cycle once a week, in about 77 years. In real life most backup units see far fewer full cycles, so calendar ageing, heat and how full you store it matter more. Store it around 50–80% if it will sit for months, and top it up every few months.

Runtime estimates

These are our own estimates, not measurements. We take the rated capacity (1,024 Wh), assume about 85% of it reaches your devices after inverter and conversion losses (1,024 × 0.85 ≈ 870 Wh), then divide by a typical appliance draw. Your appliance’s real wattage is on its label or in its manual, and it changes with settings, temperature and age, so treat these as ballpark figures. Our power station size calculator does the same maths with your own appliance list.

ApplianceTypical drawEstimated runtime on Anker SOLIX C1000 Gen 2
Wi-Fi router + modem20Wabout 44 h
CPAP (no humidifier or heated hose)40Wabout 22 h (humidifier use can double or triple this)
Laptop60Wabout 15 h
Full-size refrigerator (average while cycling)60Wabout 15 h (about 1.4 kWh a day; start-up surge is much higher)
50-inch LED TV100Wabout 8.7 h
Box fan50Wabout 17 h
5,000 BTU window AC450Wabout 1.9 h (compressor start-up surge)
1/3 hp sump pump (running)800Wabout 1.1 h (start-up surge 2–3× running watts)
Coffee maker1,000Wabout 50 min
Space heater (high)1,500Wabout 35 min
Formula: rated Wh × 0.85 ÷ appliance watts. Typical draws are common US figures, not measurements of a specific product.

US safety & setup notes

  • Plug devices straight in. Use a heavy-duty extension cord rated for the load if you must run power to another room. Don’t daisy-chain power strips, and keep cords out of walkways.
  • Don’t connect it to your home wiring. At this size it is meant for plug-in devices. Never use a male-to-male cord to feed a wall outlet; it can energize the utility line.
  • Indoors is fine; heat is not. Battery power stations make no exhaust, so unlike a gas generator they are safe to run indoors. Keep vents clear, keep it off carpet if it runs hot, and charge it within the temperature range in the manual (most LiFePO4 units will not charge below about 32°F).
  • Medical devices: if someone depends on a CPAP or oxygen concentrator, check the device maker’s guidance for battery and inverter use and keep a second backup plan. A power station is not a substitute for medical advice.

Pros & cons

What we like

  • 2,000W continuous / 3,000W peak
  • Light for the class at 24.9 lb
  • 1,600W UltraFast AC charging
  • <10 ms UPS
  • AC + solar charging at the same time

What we don’t

  • Not expandable
  • 600W solar ceiling
  • UltraFast charging needs warm cells

Alternatives

If the Anker SOLIX C1000 Gen 2 isn’t quite right, these are the models we would look at next:

Head-to-heads: C1000 Gen 2 vs DELTA 3 Plus and C1000 Gen 2 vs Jackery 1000 v2.

Verdict

For most people buying a single 1 kWh power station for outages and weekends away, the C1000 Gen 2 is one of the best balances of weight, output and charging speed. Buy something expandable instead if you already suspect 1 kWh won’t be enough.

Our score: 8.7/10. Top marks for output-to-weight and charging speed; marked down for no expansion and a modest solar ceiling. The score is an editorial judgement of value and features against similar models; it is not a lab test result.

Related: EcoFlow vs Anker SOLIX, best portable power station, best portable power station for camping.

FAQ: Anker SOLIX C1000 Gen 2 review questions

Can the Anker SOLIX C1000 Gen 2 be expanded?

No. Anker states the Gen 2 has no expansion feature in order to reduce size and weight. The original C1000 supports an expansion battery.

How long will the Anker SOLIX C1000 Gen 2 run a refrigerator?

Roughly 15 h for a typical full-size fridge averaging about 60W while it cycles (1,024 Wh × 0.85 ÷ 60W). An older or bigger fridge, a hot kitchen or frequent door opening will cut that. The fridge’s start-up surge also has to fit within the unit’s surge rating; at 2,000W continuous that is rarely a problem for a household fridge.

Can the Anker SOLIX C1000 Gen 2 run a space heater?

Yes, a 1,500W space heater is within its 2,000W rating, but it will only last 35 min on high. Heaters are one of the least efficient things to run from a battery; an electric blanket (about 50–100W) keeps you warm for many times longer. See can a portable power station run a space heater.

Can you charge the Anker SOLIX C1000 Gen 2 with solar panels?

Yes. The maker lists solar input as 600W max (11–60V). Stay inside the voltage window, because exceeding it can damage the unit, and expect real-world panel output well below the panel’s label. Our solar charging guide explains series vs parallel wiring.

Can the Anker SOLIX C1000 Gen 2 be used as a UPS?

The maker lists a switchover time of <10 ms, which is fast enough for most routers, modems, CPAP machines and desktop PCs. It is still not the same as an online (double-conversion) UPS, so test it with your own equipment before relying on it. More in can you use a portable power station as a UPS.

Is the Anker SOLIX C1000 Gen 2 worth it?

It is worth it if you want the most output per pound in the 1 kWh class. Look elsewhere if you might want more capacity later: it is not expandable. In short: a light, powerful 1 kWh LiFePO4 station: 2,000W output, 600W solar and a 10 ms UPS at under 25 lb. The catch is that it cannot be expanded. Prices change often, so check the current price before you buy.

How many amp hours is the Anker SOLIX C1000 Gen 2?

Power stations are rated in watt-hours (Wh), not amp-hours. The Anker SOLIX C1000 Gen 2 stores 1,024 Wh, which works out to about 85 Ah at 12 V (1,024 Wh ÷ 12 V). Compare power stations by Wh: an amp-hour figure only means something next to its voltage.

How we researched this: GridlessLab has not tested this unit hands-on. This review is based on the manufacturer’s published US specifications (checked against the official product page in November 2026) and our own runtime calculations; we did not incorporate third-party test results or owner reports. Where a spec could not be confirmed on the official page, we left it out rather than guess.

GE

GridlessLab Editorial

The GridlessLab editorial team writes research-based guides to portable power stations and solar generators for US homes, RVs and campsites. About GridlessLab & how we work →