Independent reviews for US buyers · Reader-supported

Reader-supported: we may earn a commission from brands when you buy through our links, at no extra cost to you. Affiliate Disclosure

Reviews · 3,072 Wh

Anker SOLIX F3000 Review: Specs, Runtime & Who Should Buy It

By GridlessLab Editorial · Updated November 17, 2026

Check current price →Opens the retailer’s site. We may earn a commission.

Quick verdict

8.2/10
Rated capacity3,072 Wh
AC output3,600 W

A 3 kWh, 3,600W unit on wheels with a TT-30R RV port, 2,400W of solar input and EV-charger charging. Heavy at 91.5 lb but easy to roll.

Figures on this page are manufacturer specifications; we have not measured this unit ourselves.

Overview

The Anker SOLIX F3000 is a 3,072 Wh LFP power station on wheels with a pull rod, a 3,600W total AC output, NEMA 5-20R outlets, a TT-30R RV plug and solar inputs totalling 2,400W.

We haven’t tested it ourselves. This Anker SOLIX F3000 review uses Anker’s official US spec sheet and our own runtime maths. Its most unusual trick is charging at up to 3,600W from a Level 2 EV charger (J1772) using Anker’s adapter.

Who it’s for

Is the Anker SOLIX F3000 right for you?

  • Buy it if: you want 3 kWh you can roll around
  • Buy it if: you have an RV with a TT-30 inlet
  • Buy it if: you want big solar input
  • Skip it if: you need 240V output
  • Skip it if: you need to lift it into a vehicle often

Key specs

Rated capacity3,072 Wh
Battery chemistryLFP
Rated cycle life4,000 cycles
Continuous AC output3,600W
Surge / boost4,860W SurgePad
AC outletsNEMA 5-20R outlets (2,400W max each, 3,600W total) plus TT-30R
USB & DC outputsUSB-C and USB-A
Max solar input2,400W total (1,600W high-PV 11–165V + 800W low-PV 11–60V)
Wall charging120V 15A wall; 240V 3,600W via EV charging adapter (J1772)
ExpandableYes – expansion battery port
Weight91.5 lb
Warranty5 years
Also worth knowingWheels and pull rod; Anderson port
Manufacturer specifications from the official Anker SOLIX product page, checked November 2026. Not measured by us.

What stands out

Output

Each NEMA 5-20R outlet handles up to 2,400W, with 3,600W total. Anker’s “SurgePad” figure is 4,860W for start-up loads.

Solar

1,600W high-voltage (11–165V) plus 800W low-voltage (11–60V) inputs for 2,400W total.

EV charger charging

With the EV charging adapter (J1772 Type 1), it can take 240V at up to 3,600W, a clever option for homes with a Level 2 charger.

Weight

91.5 lb with wheels and a pull rod. Anker lists a 5-year warranty and 4,000 cycles.

How it compares

Here is how the Anker SOLIX F3000 lines up against the models we would cross-shop it with. “Wh per lb” is a quick way to compare how much energy you carry for the weight.

ModelCapacityAC outputWeightWh per lbMax solar
Anker SOLIX F30003,072 Wh3,600W91.5 lb34 Wh/lb2,400W total
PECRON F3000LFP3,072 Wh3,600W63.3 lb49 Wh/lb1,600W max
EcoFlow DELTA Pro 34,096 Wh4,000W113.5 lb36 Wh/lb2,600W total
Anker SOLIX F3800 Plus3,840 Wh6,000W136.7 lb28 Wh/lb3,200W total
BLUETTI Apex 3002,764.8 Wh3,840W83.8 lb33 Wh/lbUp to 6,400W with the SolarX 4K add-on
Manufacturer specifications, checked November 2026.

What the cycle rating means: Anker SOLIX F3000 is rated for 4,000 cycles. One full charge and discharge every day would use that up in about 11 years; a full cycle once a week, in about 77 years. In real life most backup units see far fewer full cycles, so calendar ageing, heat and how full you store it matter more. Store it around 50–80% if it will sit for months, and top it up every few months.

Runtime estimates

These are our own estimates, not measurements. We take the rated capacity (3,072 Wh), assume about 85% of it reaches your devices after inverter and conversion losses (3,072 × 0.85 ≈ 2,611 Wh), then divide by a typical appliance draw. Your appliance’s real wattage is on its label or in its manual, and it changes with settings, temperature and age, so treat these as ballpark figures. Our power station size calculator does the same maths with your own appliance list.

ApplianceTypical drawEstimated runtime on Anker SOLIX F3000
Wi-Fi router + modem20Wabout 131 h
CPAP (no humidifier or heated hose)40Wabout 65 h (humidifier use can double or triple this)
Laptop60Wabout 44 h
Full-size refrigerator (average while cycling)60Wabout 44 h (about 1.4 kWh a day; start-up surge is much higher)
50-inch LED TV100Wabout 26 h
Box fan50Wabout 52 h
5,000 BTU window AC450Wabout 5.8 h (compressor start-up surge)
1/3 hp sump pump (running)800Wabout 3.3 h (start-up surge 2–3× running watts)
Coffee maker1,000Wabout 2.6 h
Space heater (high)1,500Wabout 1.7 h
Formula: rated Wh × 0.85 ÷ appliance watts. Typical draws are common US figures, not measurements of a specific product.

US safety & setup notes

  • Plug devices straight in. Use a heavy-duty extension cord rated for the load if you must run power to another room. Don’t daisy-chain power strips, and keep cords out of walkways.
  • Never backfeed a wall outlet. A “suicide cord” (male-to-male plug) can energize the utility line and kill a line worker. To power hard-wired circuits, have a licensed electrician install a transfer switch or interlock with a power inlet, as the National Electrical Code (NEC) requires for standby and optional standby systems.
  • Indoors is fine; heat is not. Battery power stations make no exhaust, so unlike a gas generator they are safe to run indoors. Keep vents clear, keep it off carpet if it runs hot, and charge it within the temperature range in the manual (most LiFePO4 units will not charge below about 32°F).
  • Medical devices: if someone depends on a CPAP or oxygen concentrator, check the device maker’s guidance for battery and inverter use and keep a second backup plan. A power station is not a substitute for medical advice.

Pros & cons

What we like

  • 3,072 Wh
  • 3,600W total output
  • 2,400W solar
  • Wheels and pull rod
  • 5-year warranty

What we don’t

  • 91.5 lb
  • 120V only
  • No UPS time listed on the page we checked

Alternatives

If the Anker SOLIX F3000 isn’t quite right, these are the models we would look at next:

Verdict

The F3000 is a strong 3 kWh pick for RVs and 120V home backup, especially if you have solar or an EV charger. For 240V circuits, step up to the F3800 Plus or DELTA Pro 3.

Our score: 8.2/10. High marks for output, solar and charging options; marked down for 120V-only output and weight. The score is an editorial judgement of value and features against similar models; it is not a lab test result.

Related: best power station for a sump pump, best solar generator for RV.

FAQ: Anker SOLIX F3000 review questions

Can the Anker F3000 power an RV?

Yes. It has a TT-30R outlet for 30A RV plugs, within its 3,600W total limit.

How long will the Anker SOLIX F3000 run a refrigerator?

Roughly 44 h for a typical full-size fridge averaging about 60W while it cycles (3,072 Wh × 0.85 ÷ 60W). An older or bigger fridge, a hot kitchen or frequent door opening will cut that. The fridge’s start-up surge also has to fit within the unit’s surge rating; at 3,600W continuous that is rarely a problem for a household fridge.

Can the Anker SOLIX F3000 run a space heater?

Yes, a 1,500W space heater is within its 3,600W rating, but it will only last 1.7 h on high. Heaters are one of the least efficient things to run from a battery; an electric blanket (about 50–100W) keeps you warm for many times longer. See can a portable power station run a space heater.

Can you charge the Anker SOLIX F3000 with solar panels?

Yes. The maker lists solar input as 2,400W total (1,600W high-PV 11–165V + 800W low-PV 11–60V). Stay inside the voltage window, because exceeding it can damage the unit, and expect real-world panel output well below the panel’s label. Our solar charging guide explains series vs parallel wiring.

Can the Anker SOLIX F3000 be used as a UPS?

The official spec page we checked does not list a UPS switchover time, so we can’t confirm it. Many units offer pass-through charging, which is not the same thing: if switchover is slow, a desktop PC may reboot. Test with your own gear first, and see our UPS guide.

A note on tax credits: the federal 30% Residential Clean Energy Credit (IRC §25D) no longer applies to purchases made after December 31, 2025, and even before that it only covered battery storage of 3 kWh or more installed in connection with your home, which most plug-in portable units never met. Some states and utilities run their own rebates, so check locally. This is general information, not tax advice.

Is the Anker SOLIX F3000 worth it?

It is worth it if you want 3 kWh you can roll around. Look elsewhere if you need 240V output. In short: a 3 kWh, 3,600W unit on wheels with a TT-30R RV port, 2,400W of solar input and EV-charger charging. Heavy at 91.5 lb but easy to roll. Prices change often, so check the current price before you buy.

How many amp hours is the Anker SOLIX F3000?

Power stations are rated in watt-hours (Wh), not amp-hours. The Anker SOLIX F3000 stores 3,072 Wh, which works out to about 256 Ah at 12 V (3,072 Wh ÷ 12 V). Compare power stations by Wh: an amp-hour figure only means something next to its voltage.

How we researched this: GridlessLab has not tested this unit hands-on. This review is based on the manufacturer’s published US specifications (checked against the official product page in November 2026) and our own runtime calculations; we did not incorporate third-party test results or owner reports. Where a spec could not be confirmed on the official page, we left it out rather than guess.

GE

GridlessLab Editorial

The GridlessLab editorial team writes research-based guides to portable power stations and solar generators for US homes, RVs and campsites. About GridlessLab & how we work →