Overview
Anker’s SOLIX C1000 Gen 2 packs 1,024 Wh of LiFePO4 into a 24.9 lb box with a 2,000W inverter (3,000W peak). That is more output and less weight than most 1 kWh rivals, and it is why it keeps showing up in “best value” lists.
This Anker SOLIX C1000 Gen 2 review is research-based: we used Anker’s official US spec sheet and our own runtime maths, and we have not tested the unit ourselves. Our yardstick for any backup battery is simple: does it carry the essentials through a long evening, and can it refill fast once the power is back? The C1000 Gen 2 is built around that second part.
Who it’s for
Is the Anker SOLIX C1000 Gen 2 right for you?
- Buy it if: you want the most output per pound in the 1 kWh class
- Buy it if: you get short, frequent outages and need fast recharges
- Buy it if: you want TOU (time-of-use) scheduling from the app
- Skip it if: you might want more capacity later: it is not expandable
- Skip it if: you need lots of solar: 600W max is lower than EcoFlow or BLUETTI rivals
Key specs
| Rated capacity | 1,024 Wh |
| Battery chemistry | LiFePO4 (LFP) |
| Rated cycle life | 4,000 cycles to 80% |
| Continuous AC output | 2,000W |
| Surge / boost | 3,000W peak |
| AC outlets | 120V AC outlets, 2,000W max |
| USB & DC outputs | USB-C up to 140W, USB-A |
| Max solar input | 600W max (11–60V) |
| Wall charging | 1,200W standard; 1,600W UltraFast mode (app) |
| UPS / switchover | <10 ms |
| Expandable | No (Anker says the C1000 Gen 2 is not expandable) |
| Weight | 24.9 lb |
| Also worth knowing | Time-of-Use mode in the app; up to 10 devices at once |
What stands out
2,000W from a 25 lb box
The 2,000W continuous rating (3,000W peak) covers things like a microwave, a coffee maker or a small space heater that 1,500W and 1,800W rivals struggle with. Anker’s spec sheet also lists 1,800W bypass when plugged into the wall, so the unit can pass grid power through to bigger loads.
Fast wall charging, with a caveat
Standard AC charging is 1,200W, and an UltraFast mode in the app raises it to 1,600W. Anker’s own FAQ notes UltraFast only works when the cells are above about 68°F and recommends using it only when needed to protect battery life. That is an honest caveat worth remembering in a cold garage.
A real 10 ms UPS
Anker lists a sub-10 ms switchover and specifically mentions CPAP machines and laptops. For a router, modem and a PC, that’s quick enough to ride through an outage without a reboot in most cases.
No expansion, by design
Anker says plainly that the Gen 2 dropped the expansion port to save size and weight, and points people who want expansion to the original C1000. If 1 kWh will always be enough for you, this is not a problem; if you hope to grow into whole-fridge, multi-day backup, look at the C2000 Gen 2 or DELTA 3 Plus.
How it compares
Here is how the Anker SOLIX C1000 Gen 2 lines up against the models we would cross-shop it with. “Wh per lb” is a quick way to compare how much energy you carry for the weight.
| Model | Capacity | AC output | Weight | Wh per lb | Max solar |
|---|---|---|---|---|---|
| Anker SOLIX C1000 Gen 2 | 1,024 Wh | 2,000W | 24.9 lb | 41 Wh/lb | 600W max |
| EcoFlow DELTA 3 Plus | 1,024 Wh | 1,800W | 27.6 lb | 37 Wh/lb | 1,000W total |
| DJI Power 1000 V2 | 1,024 Wh | 2,600W | 31.3 lb | 33 Wh/lb | n/a |
| Jackery Explorer 1000 v2 | 1,070 Wh | 1,500W | 23.8 lb | 45 Wh/lb | 400W max |
| BLUETTI Elite 100 V2 | 1,024 Wh | 1,800W | 25 lb | 41 Wh/lb | 1,000W max |
What the cycle rating means: Anker SOLIX C1000 Gen 2 is rated for 4,000 cycles to 80%. One full charge and discharge every day would use that up in about 11 years; a full cycle once a week, in about 77 years. In real life most backup units see far fewer full cycles, so calendar ageing, heat and how full you store it matter more. Store it around 50–80% if it will sit for months, and top it up every few months.
Runtime estimates
These are our own estimates, not measurements. We take the rated capacity (1,024 Wh), assume about 85% of it reaches your devices after inverter and conversion losses (1,024 × 0.85 ≈ 870 Wh), then divide by a typical appliance draw. Your appliance’s real wattage is on its label or in its manual, and it changes with settings, temperature and age, so treat these as ballpark figures. Our power station size calculator does the same maths with your own appliance list.
| Appliance | Typical draw | Estimated runtime on Anker SOLIX C1000 Gen 2 |
|---|---|---|
| Wi-Fi router + modem | 20W | about 44 h |
| CPAP (no humidifier or heated hose) | 40W | about 22 h (humidifier use can double or triple this) |
| Laptop | 60W | about 15 h |
| Full-size refrigerator (average while cycling) | 60W | about 15 h (about 1.4 kWh a day; start-up surge is much higher) |
| 50-inch LED TV | 100W | about 8.7 h |
| Box fan | 50W | about 17 h |
| 5,000 BTU window AC | 450W | about 1.9 h (compressor start-up surge) |
| 1/3 hp sump pump (running) | 800W | about 1.1 h (start-up surge 2–3× running watts) |
| Coffee maker | 1,000W | about 50 min |
| Space heater (high) | 1,500W | about 35 min |
US safety & setup notes
- Plug devices straight in. Use a heavy-duty extension cord rated for the load if you must run power to another room. Don’t daisy-chain power strips, and keep cords out of walkways.
- Don’t connect it to your home wiring. At this size it is meant for plug-in devices. Never use a male-to-male cord to feed a wall outlet; it can energize the utility line.
- Indoors is fine; heat is not. Battery power stations make no exhaust, so unlike a gas generator they are safe to run indoors. Keep vents clear, keep it off carpet if it runs hot, and charge it within the temperature range in the manual (most LiFePO4 units will not charge below about 32°F).
- Medical devices: if someone depends on a CPAP or oxygen concentrator, check the device maker’s guidance for battery and inverter use and keep a second backup plan. A power station is not a substitute for medical advice.
Pros & cons
What we like
- 2,000W continuous / 3,000W peak
- Light for the class at 24.9 lb
- 1,600W UltraFast AC charging
- <10 ms UPS
- AC + solar charging at the same time
What we don’t
- Not expandable
- 600W solar ceiling
- UltraFast charging needs warm cells
Alternatives
If the Anker SOLIX C1000 Gen 2 isn’t quite right, these are the models we would look at next:
- EcoFlow DELTA 3 Plus: expandable with 1,000W solar, but heavier
- DJI Power 1000 V2: even more output (2,600W) in a heavier body
- Jackery Explorer 1000 v2: lighter still but only 1,500W
- BLUETTI Elite 100 V2: similar weight with 1,000W solar input
Head-to-heads: C1000 Gen 2 vs DELTA 3 Plus and C1000 Gen 2 vs Jackery 1000 v2.
Verdict
For most people buying a single 1 kWh power station for outages and weekends away, the C1000 Gen 2 is one of the best balances of weight, output and charging speed. Buy something expandable instead if you already suspect 1 kWh won’t be enough.
Our score: 8.7/10. Top marks for output-to-weight and charging speed; marked down for no expansion and a modest solar ceiling. The score is an editorial judgement of value and features against similar models; it is not a lab test result.
Related: EcoFlow vs Anker SOLIX, best portable power station, best portable power station for camping.
FAQ: Anker SOLIX C1000 Gen 2 review questions
Can the Anker SOLIX C1000 Gen 2 be expanded?
No. Anker states the Gen 2 has no expansion feature in order to reduce size and weight. The original C1000 supports an expansion battery.
How long will the Anker SOLIX C1000 Gen 2 run a refrigerator?
Roughly 15 h for a typical full-size fridge averaging about 60W while it cycles (1,024 Wh × 0.85 ÷ 60W). An older or bigger fridge, a hot kitchen or frequent door opening will cut that. The fridge’s start-up surge also has to fit within the unit’s surge rating; at 2,000W continuous that is rarely a problem for a household fridge.
Can the Anker SOLIX C1000 Gen 2 run a space heater?
Yes, a 1,500W space heater is within its 2,000W rating, but it will only last 35 min on high. Heaters are one of the least efficient things to run from a battery; an electric blanket (about 50–100W) keeps you warm for many times longer. See can a portable power station run a space heater.
Can you charge the Anker SOLIX C1000 Gen 2 with solar panels?
Yes. The maker lists solar input as 600W max (11–60V). Stay inside the voltage window, because exceeding it can damage the unit, and expect real-world panel output well below the panel’s label. Our solar charging guide explains series vs parallel wiring.
Can the Anker SOLIX C1000 Gen 2 be used as a UPS?
The maker lists a switchover time of <10 ms, which is fast enough for most routers, modems, CPAP machines and desktop PCs. It is still not the same as an online (double-conversion) UPS, so test it with your own equipment before relying on it. More in can you use a portable power station as a UPS.
Is the Anker SOLIX C1000 Gen 2 worth it?
It is worth it if you want the most output per pound in the 1 kWh class. Look elsewhere if you might want more capacity later: it is not expandable. In short: a light, powerful 1 kWh LiFePO4 station: 2,000W output, 600W solar and a 10 ms UPS at under 25 lb. The catch is that it cannot be expanded. Prices change often, so check the current price before you buy.
How many amp hours is the Anker SOLIX C1000 Gen 2?
Power stations are rated in watt-hours (Wh), not amp-hours. The Anker SOLIX C1000 Gen 2 stores 1,024 Wh, which works out to about 85 Ah at 12 V (1,024 Wh ÷ 12 V). Compare power stations by Wh: an amp-hour figure only means something next to its voltage.
How we researched this: GridlessLab has not tested this unit hands-on. This review is based on the manufacturer’s published US specifications (checked against the official product page in November 2026) and our own runtime calculations; we did not incorporate third-party test results or owner reports. Where a spec could not be confirmed on the official page, we left it out rather than guess.